The 4-point harness fits all around the head for better support.
Soft inner cap fastened with magnets made of foam and mesh for optimum comfort.
30 holes and 9 vent channels. Front air inflow. Ventilated neck protection.
Adjustment with slip buckle. Magnet fastener. Elastic nape protection.
Riding helmet complies with Directive 89/686/EEC.
Outer fabric : 100.0% Acrylonitrile butadiene styrene (ABS) Lining : 100.0% Polyethylene (PE)
UTAC, an independent laboratory appointed by the French authorities to conduct tests to establish compliance of safety equipment in accordance with the directives issued by the European Commission in Brussels. Recognised for its technical expertise, the laboratory is one of the official laboratories of independent European body EuroNCAP. UTAC also conducts tests on behalf of the United Nations. It has approved this helmet for use throughout the EU.
Tested in an independent laboratory in compliance with current regulations.
riders who ride frequently, one to several times a day, protecting the head from impact in case of a fall.
Wipe with a damp sponge.
Store away from heat sources such as heating appliances or the parcel shelf of a car in the sun, as this can degrade the protective performance of the polystyrene padding.
For horse riding. REPLACE ANY HELMET THAT HAS SUFFERED AN IMPACT
Adjusting the helmet
For optimal protection, the helmet should completely cover the head. However, it shouldn't be too tight, as this could cause compression points. When the straps are correctly adjusted, the helmet should be stable and not tip forwards, backwards, or to the sides when you shake your head.
For optimal fit, the strap of the helmet should be positioned around the throat an not the chin.
The helmet is designed to completely or partially absorb impacts to the rider's skull in the event of a fall or violent impact to the head. When impacted, the harness and/or padding deforms or breaks in such a way as to absorb the energy of the impact. AS ANY DAMAGE SUFFERED BY THE PROTECTIVE PADDING MAY NOT BE VISIBLE, THE HELMET SHOULD BE REPLACED IN HE EVENT OF ANY IMPACT.
5 vents on the outer shell + inner ventilation channels (4 + 5). 30 ventilation holes, facing forwards in the direction that the air enters and facing backwards in the direction that heat is evacuated. The polystyrene skull cap has ventilation channels that aid air flow.
Breathable 3D mesh fabric around the ventilation areas and synthetic suede for greater comfort.
Harness lined with suede for maximum comfort. Magnetic quick-release prevents any pinching. The back for the harness is elasticated to make it easier to get your hair through.
Information on standards
EN 1384 certified helmets can still be worn in training and competitions. However, some organizations may require other standards for their competitions. If in doubt, we recommend that you consult the competition organiser.
The harmonised standard EN 1384 was repealed in October 2014. Until a new version is issued, in order for them to be sold in Europe, all helmets produced after 4 November 2014 must undergo and be CE marked. This mark must be accompanied either by Directive 89/686/EEC, or by the VG1 01.040 2014-12 document.
Wipe with a damp sponge.
You may also be interested in these products
* The prices listed on the site are the prices recommended by DECATHLON SA's central purchasing department.