Protects the neck. 4 point harness.
Inner cap fastened with magnets, made of foam and mesh for greater comfort.
30 ventilation holes and 9 ventilation channels. Ventilated neck protection.
Harness can be adjusted using sliding buckles and a magnetic fastener.
Riding helmet complies with Directive 89/686/EEC.
Outer shell: ABS (Acrylonitrile Butadiene Styrene); Vents / button: painted or chromed ABS; Skull cap: expanded polystyrene. Fabric: Polyester and PU polyurethane suede.
UTAC, an independent laboratory appointed by the French authorities to conduct tests to establish compliance of safety equipment in accordance with the directives issued by the European Commission in Brussels. Recognised for its technical expertise, the laboratory is one of the official laboratories of independent European body EuroNCAP. UTAC also conducts tests on behalf of the United Nations. It has approved this helmet for use throughout the EU.
Tested in an independent laboratory in compliance with current regulations.
protecting the rider's head from impact in the event of a fall.
Wipe with a damp sponge.
Store away from heat sources such as heating appliances or the parcel shelf of a car in the sun, as this can degrade the protective performance of the polystyrene padding.
For horse riding. REPLACE ANY HELMET THAT HAS SUFFERED AN IMPACT
For optimal protection, the helmet should be in close contact with the head without squeezing it. When the harness is properly adjusted the helmet should not slide forward, back, or from side to side.
For optimal support, the harness must go under the throat, like a chinstrap, not over the chin.
The helmet is designed to absorb some of the energy from an impact through partial deformation of the shell or of the protective padding, or both. DAMAGE MAY NOT BE VISIBLE, BUT ANY HELMET THAT HAS SUFFERED AN IMPACT MUST BE REPLACED.
5 vents on the outer shell + inner ventilation channels (4 + 5). 30 ventilation holes, facing forwards in the direction that the air enters and facing backwards in the direction that heat is evacuated. The polystyrene skull cap has ventilation channels that aid air flow. Air cooling system.
Ventilation zones with 3D mesh and suede for comfort.
Harness lined with suede for maximum comfort. Magnetic quick-release prevents any pinching. The back for the harness is elasticated to make it easier to get your hair through.
EN 1384 certified helmets can still be worn in training and competitions. However, some organizations may require other standards for their competitions. If in doubt, we recommend that you consult the competition organiser.
You may also be interested in these products
* The prices listed on the site are the prices recommended by DECATHLON SA's central purchasing department.